-
To start the LexiCom server.
-
From the AS/400 command line, type the command
STRLEXSVR to start the LexiCom server.
The server will take a few minutes to start.
The server is fully started when port 1099 and the HTTP(/S) port (if using
AS2) are active.
If using only the FTP(/S) and/or HTTP(/S) protocols, the server is fully
started when port 1099 is active. Additionally, the message 'LexiCom
AS/400 process is now running.' is written to the QSYSOPR
log.
-
You can easily view the existence of these ports from System i Navigator
(under ), or you can type the WRKTCPSTS or the
netstat command from the AS/400 command line and then
select Option 3 (Work with IPv4 connection status).
-
To stop the Cleo LexiCom server.
-
Type the command ENDLEXSVR from the AS/400 command
line.
You can also stop the Cleo LexiCom
server from the Cleo LexiCom UI
running through the IFS mapped drive. Select the menu option.
A dialog box appears asking you to confirm that you want to stop the LexiCom
AS/400 process.
The message, 'LexiCom AS/400 process is stopping…' is
written to the QSYSOPR log.
-
Click on the "Yes" button and the LexiCom AS/400 process will be stopped and
the message ‘LexiCom AS/400 process has stopped.’ will be written to the
QSYSOPR log.
It may take several minutes for the server to stop, especially if the server
is currently processing messages.
-
You can verify the server has stopped by checking the port connections as
described above or by checking the QSYSOPR log for the
message ‘LexiCom AS/400 process has stopped.’.
When you want to start the Cleo LexiCom application
again on the AS/400, you must run the STRLEXSVR command from the AS/400 command
line.
